Week 1_ 2/6/19

For the first week of this semester, we were still organizing the new facility and moving our tools around. The new building is larger than the previous in terms of the number of rooms, but the individual rooms are not large and tall enough to house the half and full-scale models. Today, we claimed space and tables in the main meeting room for the half-scale team. Two tables were pushed together for a working area and a third table was placed against the beams to hold the bogie, components, and tools. We found our bogies within the boxes of stuff and was able to set up a computer station with the raspberry pi, monitor, and printer that was found.

Comments

Post a Comment

Popular posts from this blog

Week 3_ 2/20/19

Image
Dr. Furman told us that we are allowed a small space during Maker Faire and would have to shorten the length of the track. A couple of our team members when to the courtyard at SJSU where the half-scale track was being held and found that there is a part that can be easily sectioned off. We will keep 18ft of the track including the slope and y-junction. The legs will also be cut to around 4ft so that the bogie will just hover over the floor. This week, I found a pair of Xbee modules in a box while looking through an unclaimed cabinet brought from the old warehouse. With the 2 S1 edition modules was also an Xbee shield which will be used to fit onto the Arduino.   Looking through the Sparkfun website where the Xbees are sold, shows that the module takes in 3.3V and 50mA. The range of the Xbee is 300ft which will be able to accomplish our goals.  Figure 1. Xbee module                       Figure 2. Shield for Arduino  It was found that it could have been the Small-sca
Read more

Week 7_ 3/20/19

Image
I purchased the 10 NRFL01 wireless modules on Amazon for $11. We will be using 1 of them for the master bogie. I researched how to set up the modules while they are being shipped and have found example codes for the receiver and transmitter code shown in Figure 1 below and have tried to see if it will work. It seems that the code is sending the "Hello World" text but with noise/ junk between each sent message on the Serial Monitor.                         Figure 1.a. Receiver module code on Arduino                       Figure 1.b Transmitter code on Arduino The wiring should be as in Figure 2 below with the supply voltage being 3.3V instead of 5V. Figure 2. Arduino to NRF24L01 wiring This information was found on:  https://howtomechatronics.com/tutorials/arduino/arduino-wireless-communication-nrf24l01-tutorial/
Read more